D400.1 | D600.1 | D1000.1AMPLIFIER INSTALLATION MANUALD300.2 | D300.4 | D600.4
10Mounting LocationsEngine CompartmentNever mount this unit in the engine compartment. Mounting the unit in the engine compartment will void your warr
113) Trim the power cable within 18 inches (45.7mm) of the positive battery post and splice in a in-line fuse holder. DO NOT install the fuse at th
128) Connect from source signal by connecting the RCA audio cables to the input jacks at the ampli-er. 9) Connect the car speakers. Speakers s
13+12V GNDREM2MINPOWERPROTECTSPEAKERFUSE 20AX2FLFRRLRR+12V GNDREM2MINPOWERPROTECTSPEAKERFUSE 20AX2FLFRRLRR+12V GNDREM2MINPOWERPROTECTSPEAKERFUSE 20AX2
14Installing the Remote Level Controller The D400.1, D600.1, & D1000.1 come packaged with a remote level control. This allows you to control the l
15 Adjustment of Built-In Crossover (All Models)Placing the switch in the FULL position sets the amplier to Full Range. This setting allows A
041807Diamond WarrantyDiamond Audio warrants this product to be free from defects in material and workmanship for a period of one (1) year from the or
2Congratulations!Thank you for choosing a new Diamond Audio amplier. Diamond Audio ampliers are engineered and produced with the highest quality mat
3 Frequency Response: 20Hz to 20KHz +/-1 dBSignal to Noise Ratio: >90dBA (20 to 20kHz)Channel Separation 60dBTHD+N(Total Harmoni
4Connections and ControlsThis section describes all of the terminals and adjustments.4 gauge power and ground wire is recommended for all models.2 and
54 gauge power and ground wire is recommended for all models.Connections and ControlsThis section describes all of the terminals and adjustments. Mono
6RCA Input and Pass-Thru Output - These RCA jacks allow for a normal Left and Right channel signal input. Simply connect to the source unit using RCA
7Strapping Amplifiers (D600.1, D1000.1)MASTERSLAVEWiring 1) Select one amplier to be the master amplier and one amplier to be the slave amplier. (
9Installation GuidelinesTools and SuppliesListed below are the tools and supplies needed to complete this installation:• Volt/Ohm Meter• Wire stripp
Comments to this Manuals